Planting with a “flare”

Anyone who plants or cares for woody plants eventually hears the term “root flare” (or root crown). It’s easy to describe a root flare (it’s the region where stem or trunk morphs into roots). What’s sometimes difficult or even impossible is finding it in improperly planted trees and shrubs.

Conifer root flare
Angiosperm root flare

 

 

 

 

One of the primary causes of tree and shrub failure is improper planting depth. This is not a problem with bare-root plants, as you can easily see the region of transition. During planting you should make sure that the root flare is at grade, so that the roots are underground and the stem/trunk is above ground. The only mistake you can make with bare-root plants is to plant them upside down.

Grafted bare root trees clearly show root flare

The problem really started with the advent of containerized and balled-in-burlap (B&B) plants. This technology is less than 100 years old, and before it existed everything was either planted from seed or from bare-root stock. It’s possible to use containers and B&B properly for temporarily housing trees and shrubs, but increasingly automated production methods with unskilled workers and undereducated supervisors means increasing numbers of poorly planted woody plants entering the retail market.

Vine maple planted too deeply in container
Tree buried too deeply in burlap

 

 

 

 

 

 

I’ve written earlier posts about how to select plants at the nursery. As you’ll note, finding the root flare can often be impossible without removing container media or B&B burlap. Because so many people are unaware of the problem or unwilling to disturb the root ball, these plants are then installed with the root flare still buried.

Lilac planted too deeply
Pine tree planted too deeply

 

 

 

 

 

 

Why does it matter if part of the trunk is underground? For some species, it really doesn’t matter. Wetland species, for instance, can tolerate low soil oxygen levels and submerged trunks. But most of us are not planting wetland species, and many ornamentals are not tolerant of this treatment. Roots that are buried too deeply don’t receive enough oxygen to survive, and the plants respond by trying to create a new root system. These adventitious roots are unable to supply enough water to the growing crown, however, meaning shrubs and trees suffer chronic drought stress when the rate of evaporation exceeds the ability of these substandard root systems to supply water.

With only skimpy adventitious root system to take up water…
…this tree suffers chronic drought stress every summer

 

 

 

 

 

 

There are other problems, too. Stem and trunk tissues of non-wetland species are not adapted to being buried. The excessive moisture and lack of oxygen contribute to the attack of opportunistic pests and diseases, both of which can cause irreversible damage and eventual death. You can even see this happening to plants in the nursery.

Rotted trunk clearly visible in improperly bagged B&B

Finally, consider this landscape evidence of the impact of buried root flares. These magnolias are all planted on the campus at Princeton University. The one of the left is significantly smaller than the other three. A close up of the trunks explains why.

One of these trees is not like the others
Magnolia tree under stress from being buried too deeply
This magnolia tree thrives with its root flare clearly visible

 

 

 

 

 

 

 

 

If you have newly planted trees that look more like telephone poles than trees, the best thing you can do is dig them up and plant them correctly.

Published by

Linda Chalker-Scott

Dr. Linda Chalker-Scott has a Ph.D. in Horticulture from Oregon State University and is an ISA certified arborist and an ASCA consulting arborist. She is WSU’s Extension Urban Horticulturist and a Professor in the Department of Horticulture, and holds two affiliate associate professor positions at University of Washington. She conducts research in applied plant and soil sciences, publishing the results in scientific articles and university Extension fact sheets. Linda also is the award-winning author of five books: the horticultural myth-busting The Informed Gardener (2008) and The Informed Gardener Blooms Again (2010) from the University of Washington Press and Sustainable Landscapes and Gardens: Good Science – Practical Application (2009) from GFG Publishing, Inc., and How Plants Work: The Science Behind the Amazing Things Plants Do from Timber Press (2015). Her latest effort is an update of Art Kruckeberg’s Gardening with Native Plants of the Pacific Northwest from UW Press (2019). In 2018 Linda was featured in a video series – The Science of Gardening – produced by The Great Courses. She also is one of the Garden Professors – a group of academic colleagues who educate and entertain through their blog and Facebook pages. Linda’s contribution to gardeners was recognized in 2017 by the Association for Garden Communicators as the first recipient of their Cynthia Westcott Scientific Writing Award. "The Garden Professors" Facebook page - www.facebook.com/TheGardenProfessors "The Garden Professors" Facebook group - www.facebook.com/groups/GardenProfessors Books: http://www.sustainablelandscapesandgardens.com

15 thoughts on “Planting with a “flare””

  1. Dr. Linda: looking at the pic of the lilac planted too deeply. i’ve transplanted some lilac suckers. they were less than 1 year old, hence very small. how does one figure out a trunk flare in that scenario?

    1. Corey, you should be able to see where the roots emerge. Assume that the uppermost root represents the crown and plant accordingly. In the photo shown, there are multiple trunks of one plant, but you can’t see the place where they all connect. That’s the flare.

  2. Very useful information! The US Tree Care Standard sorted the terminology:

    82.10 flare (trunk flare, root flare): 1. The area at the base of the plant’s stem or trunk where the stem or trunk broadens to form roots
    82.20 root collar: The transition zone between the flare and the root system (where the buttress roots divide)

    When this distinction is clear, growers and landscapers can more easily understand that the bottom of the flare, the root collar, should always be visible.

  3. Linda, thank you for this post and your posts about using mulch to kill grass instead of cardboard/paper. I got your message about deep mulch, but the area I’m trying to convert from lawn to garden bed contains a mature apple tree (MD z7). The grass goes right up to the trunk, which appears to go right into the grass without much flare. Will deep mulch harm the roots of my tree, or is it ok because it’s not being planted? I assume it’s about 20 years old and seems healthy. Last year a bumper crop of apples, this year no flowers but many healthy leaves and our neighbor’s apple tree a block away hasn’t flowered either. Thank you!

  4. Thanks for the info & useful pictures! We’re in Zone 8a Southeast & having air spade work done on our too-deeply buried trees (a large, mature oak, two teen dogwoods, a couple of mature magnolias & a group of mature, previously topped, Leland cypresses) now. I’m having difficulty getting specifics on aftercare, like guidelines for how much & what methods for watering, whether or now tree wells are needed, science-based (hopefully definitive) mulching type & placement, etc. The arborist is not as specific as I would like- esp about how much watering is needed for best results- & other sources contradict some of his recommendations, especially about what & how much soil/mulch/other material should go back in the flare zone. My Internet searches aren’t turning up the info. Please can you give some of this and/or direct me to another resource? Thanks again!

    1. There really is not a pat answer for how much water – you will need to monitor soil moisture, probably with your fingers, to assess this. You don’t want it soggy and you don’t want it dry. It should leave a residue on your hands and feel moist to the touch.
      Mulch deeply with arborist wood chips. Maintain a minimum of 4-6″ to reduce weeds and enhance root establishment. Don’t skimp on this step. The chips can cover the flare as trees are adapted to a coarse woody debris layer.
      You can use this university fact sheet for information on wood chips: http://cru.cahe.wsu.edu/CEPublications/FS160E/FS160E.pdf

  5. Thank you for your many articles about tree flare and proper planting – I’ve learned a lot.

    I want to soon plant a bare root tree (sugar maple, about 8 mm in diameter) on a sloped area. If I dig it a 2′ diameter hole, the upper side will be about 8″ higher than the low side. What is the ideal height for the flare to be at? I’m assuming that watering will be much easier for the first year if I have level 2′ diameter area around the tree, so should I make the level of the soil (and the flare) at the halfway point between the high and low areas of the initial hole? Or should I have the soil be much closer to the level of the high end of the initial hole? Thanks for your help.

    1. If you are planting on a slope, you want to construct a planting bed that is horizontal. That means you’ll have to use some wood or other material to hold the soil in place (like a terrace). The flare should be at soil level in this terrace.

  6. We have some established trees that we don’t want to replant. So if we remove all soil around the trunk so that the root flare is clearly showing (and we keep it that way) is that sufficient?

    1. If they are established and doing well, then you probably don’t need to do anything with them. But if they are struggling, I’d question whether they are truly established. More information on the trees’ health would be useful.

Leave a Reply to Linda Chalker-Scott Cancel reply